Administrator Guide

4 Lift the chassis and slide it into the rails installed in the rack (Figure 16). Tighten the two thumb screws and four rack screws (item 5 in
Figure 16) on each ange to secure the chassis to the rack.
On a 2-post rack, slide each rail bracket (item 4 in Figure 16) forward to the post. Tighten the two screws (item 3 in Figure 16) to
secure the bracket to each post.
Figure 16. Installing the Chassis with ReadyRails in a Threaded-Hole Rack
Using a Rack Mount Tray (Optional)
You can also use a rack mount tray to install the C9010 switch in a 2- or 4-post rack. Purchase the tray as a separate item.
NOTE
: If the use of a rack bar or Dell ReadyRails does not satisfy your C9010 installation requirements, Dell Networking
recommends using a rack mount tray to support the weight of a C9010 switch in a 2- or 4-post rack. For information about the
chassis weight and other technical specication, see Technical Specications.
24 Installing the Hardware