Administrator Guide

2 Using a at-tipped screwdriver, remove the bracket subassembly and four pins (items 1 and 2 in Figure 15) from the front and rear of
each rail. Pull on each subassembly to fully remove it.
Figure 15. Installing Tooled Rails in a Threaded-Hole Rack
3 Attach the front of each rail to the front rack posts using the screws provided with the rack.
On a 4-post rack, slide the back end of each rail (item 3 in Figure 15) so that it aligns with the back post holes at the same height.
Attach each rail to a rear post using four screws provided with the rack (item 4 in Figure 15).
Installing the Hardware
23