Users Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

981

982

983

984

985

986

987

988

989

990

● For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the

slot/port information.

static (OPTIONAL) Enter the keyword static to display only those MAC addresses

specifically configured on the switch.

vlan

vlan-id

(OPTIONAL) Enter the keyword vlan then the VLAN ID to display the MAC

address assigned to the VLAN. The range is 1 to 4094.

Command Modes

● EXEC

● EXEC Privilege

Command

History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.9(0.0) Introduced on the C9010.

9.2(1.0) Introduced on the Z9500.

8.3.19.0 Introduced on the S4820T.

8.5.1.0 Added support for 4-port 40G line cards on ExaScale.

8.3.7.0 Introduced on the S4810.

7.5.1.0 Introduced on the C-Series.

6.2.1.1 Introduced on the E-Series.

Example

Dell# show cam mac linecard 1 port-set 0

PVlanId Mac Address Region Interface

1 00:01:02:03:04:09 DYNAMIC Fo 2/0

0 74:86:7a:ff:6f:1c LOCAL_DA 00001

1 00:11:22:33:44:55 STATIC Fo 2/8

1 00:01:02:03:04:07 DYNAMIC Fo 2/0

1 00:01:02:03:04:08 DYNAMIC Fo 2/0

0 ff:ff:ff:ff:ff:ff STATIC 00001

1 00:01:02:03:04:05 DYNAMIC Fo 2/0

1 00:01:02:03:04:06 DYNAMIC Fo 2/0

show mac-address-table

Display the MAC address table.

C9000 Series

Syntax

show mac-address-table [address mac-address | interface interface | vlan

vlan-id] [aging-time] [dynamic | static] [count [vlan vlan-id] [interface

interface-type [slot [/port]]]]

Parameters

address

mac-

address

(OPTIONAL) Enter the keyword address then a MAC address in the

nn:nn:nn:nn:nn:nn format to display information on that MAC address.

dynamic (OPTIONAL) Enter the keyword dynamic to display only those MAC addresses

the switch dynamically learns. Optionally, you can also add one of these

combinations: address/mac-address, interface/interface, or vlan

vlan-id.

986 Layer 2