Users Guide

mac learning-limit reset
Reset the MAC address learning-limit error-disabled state.
C9000 Series
Syntax
mac learning-limit reset
Defaults none
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.5.1.0 Introduced on the E-Series.
show cam mac linecard (dynamic or static)
Display the CAM size and the portions allocated for MAC addresses and for MAC ACLs.
C9000 Series
Syntax
show cam mac linecard slot-id port-set port-pipe [address mac_addr |
dynamic | interface interface | static | vlan vlan-id]
Parameters
linecard slot-id (REQUIRED) Enter the keyword linecard then a slot number to select the
linecard for which to gather information. The range of C9000 slot IDs are from 0 to
11.
port-set port-
pipe
(REQUIRED) Enter the keywords port-set then a port-pipe number to specify
the port pipe for which to gather information. The range of port pipe numbers is
from 0 to 0.
address mac-
addr
(OPTIONAL) Enter the keyword address then a MAC address in the
nn:nn:nn:nn:nn:nn format to display information on that MAC address.
dynamic (OPTIONAL) Enter the keyword dynamic to display only those MAC addresses
the switch dynamically learns.
interface
interface
(OPTIONAL) Enter the keyword interface then the interface type, slot and port
information:
● For a Port Channel interface, enter the keywords port-channel then a
number.
Layer 2 985