Users Guide
or infinite parameter. In the Configuration Terminal Batch mode, you can use this command to configure
the IPv6 addresses in a dual-homing setup.
Example
Dell(conf-if-te-0/1)#ipv6 nd dns-server 1000::1 1
ipv6 nd prefix
Specify which IPv6 prefixes are included in Neighbor Advertisements.
C9000 Series
Syntax
ipv6 nd prefix {ipv6-prefix | prefix-length | default} [no-advertise] |
[no-autoconfig] [no-rtr-address] [off-link] [lifetime {valid | infinite}
{preferred | infinite}]
Parameters
ipv6-prefix
Enter an IPv6 prefix.
prefix-length
Enter the prefix then the prefix length. The length range is from 0 to 128.
default Enter the keyword default to set default parameters for all prefixes.
no-advertise Enter the keyword no-advertise to prevent the specified prefix from being
advertised.
no-autoconfig Enter the keywords no-autoconfig to disable Stateless Address
Autoconfiguration.
no-rtr-address Enter the keyword no-rtr-address to exclude the full router address from
router advertisements (the R bit is not set).
off-link Enter the keywords off-link to advertise the prefix without stating to recipients
that the prefix is either on-link or off-link.
valid-lifetime
|
infinite
Enter the amount of time that the prefix is advertised, or enter infinite for an
unlimited amount of time. The range is from 0 to 4294967295. The default is
2592000. The maximum value means that the preferred lifetime does not expire
for the valid-life time parameter.
preferred-
lifetime
| infinite
Enter the amount of time that the prefix is preferred, or enter infinite for an
unlimited amount of time. The range is from 0 to 4294967295. The default is
604800. The maximum value means that the preferred lifetime and does not
expire.
Command Modes
INTERFACE
INTERFACE (BATCH MODE)
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.2.0 Introduced on the E-Series TeraScale, C-Series, and S-Series.
IPv6 Basics 955