Users Guide

Version Description
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
8.1.1.2 Supported on the E-Series ExaScale E600i.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage
Information
The following describes the show ip interface command shown in the following example.
Lines Description
TenGigabitEther
net 0/0...
Displays the interface’s type, slot/port, and physical and line protocol status.
Internet
address...
States whether an IP address is assigned to the interface. If an IP address is
assigned, that address is displayed.
IP MTU is... Displays IP MTU value.
Inbound access... Displays the name of the configured incoming access list. If none is configured, the
phrase “not set” is displayed.
Proxy ARP... States whether proxy ARP is enabled on the interface.
Split horizon... States whether split horizon for RIP is enabled on the interface.
Poison Reverse... States whether poison for RIP is enabled on the interface.
ICMP redirects... States if ICMP redirects are sent.
ICMP
unreachables...
States if ICMP unreachable messages are sent.
Example
Dell# show ip interface tengigabitethernet 2
TenGigabitEthernet 2/0 is down, line protocol is down
Internet address is not set
IP MTU is 1500 bytes
Directed broadcast forwarding is disabled
Proxy ARP is enabled
Split Horizon is enabled
Poison Reverse is disabled
ICMP redirects are not sent
ICMP unreachables are not sent
TenGigabitEthernet 2/1 is down, line protocol is down
Internet address is not set
IP MTU is 1500 bytes
Directed broadcast forwarding is disabled
Proxy ARP is enabled
Split Horizon is enabled
Poison Reverse is disabled
ICMP redirects are not sent
ICMP unreachables are not sent
TenGigabitEthernet 2/2 is down, line protocol is down
Internet address is not set
IP MTU is 1500 bytes
Directed broadcast forwarding is disabled
Proxy ARP is enabled
Split Horizon is enabled
Poison Reverse is disabled
ICMP redirects are not sent
ICMP unreachables are not sent
IPv4 Routing
913