Users Guide

S-Series produces the following error message: %Error: Unable to read IP route table.
Example
Dell#show ip flow interface Te 1/8 189.1.1.1 63.0.0.1 protocol tcp
source-port 7898 destination-port 8
flow: 189.1.1.1 63.0.0.1 protocol 6 7868 8976
Ingress interface:Te 1/20
Egress interface:Te 1/14 to 1.7.1.2[CAM hit 103710] unfragmented packet
Te 1/10 to 1.2.1.2[CAM hit 103710] fragmented packet
show ip interface
View IP-related information on all interfaces.
C9000 Series
Syntax
show ip interface [interface | brief] [linecard slot-id] [configured]
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or number information:
● For a Loopback interface, enter the keyword Loopback then a number from 0
to 16383.
● For the Management interface, enter the keyword ManagementEthernet
then zero (0).
● For the Null interface, enter the keyword null then zero (0).
● For a Port Channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
●
For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a tunnel interface, enter the keyword tunnel then the tunnel interface
number. The range is from 1 to 16383.
● For a VLAN, enter the keyword vlan then a number from 1 to 4094.
linecard slot-id Enter the linecard slot-id parameters to specify the switch ports on a line
card. The range of slot IDs is from 0 to 2.
brief (OPTIONAL) Enter the keyword brief to view a brief summary of the interfaces
and whether an IP address is assigned.
configured (OPTIONAL) Enter the keyword configured to display the physical interfaces
with non-default configurations only.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
912 IPv4 Routing