Users Guide

summary (OPTIONAL) Enter the keyword summary to view a table listing route prefixes and
the total number of routes that can be entered into the CAM.
vrf instance (OPTIONAL) E-Series Only: Enter the keyword vrf then the VRF instance name to
show CAM information as it applies to that VRF instance.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.1.1.2 Introduced on the E-Series ExaScale E600i.
8.1.1.0 Introduced on the E-Series ExaScale.
7.9.1.0 Introduced VRF on the E-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage
Information
The following describes the show ip cam command shown in the following example.
Field Description
Index Displays the CAM index number of the entry.
Destination Displays the destination route of the index.
EC Displays the number of equal cost multipaths (ECMP) available for the default
route for non-Jumbo line cards. For Jumbo line cards, displays 0,1 when ECMP is
more than eight.
CG Displays 0.
V Displays a 1 if the entry is valid and a 0 if the entry is for a line card with Catalog
number beginning with LC-EF.
C Displays the CPU bit. 1 indicates that a packet hitting this entry is forwarded to the
CP or RP2, depending on Egress port.
Next-Hop Displays the next hop IP address of the entry.
VId Displays the VLAN ID. If the entry is 0, the entry is not part of a VLAN.
Mac Addr Displays the next-hop router’s MAC address.
Port Displays the egress interface. Use the second half of the entry to determine the
interface. For example, in the entry 17cl CP, the CP is the pertinent portion.
● CP = control processor
● RP2 = route processor 2
● Gi = Gigabit Ethernet interface
● So = SONET interface
● Te = 10-Gigabit Ethernet interface
Example
Dell#show ip cam linecard 0 port‐set 0
Destination EC C VId Mac‐Addr Port
IPv4 Routing 909