Users Guide

Version Description
9.0.0.0 Introduced on the Z9000 and added support for IPv6.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage
Information
When a static route (or a protocol route) overlaps with Management static route, the static route (or a
protocol route) is preferred over the Management Static route. Also, Management static routes and the
Management Connected prefix are not reflected in the hardware routing tables. Separate routing tables
are maintained for IPv4 and IPv6 management routes. This command manages both tables.
Related
Commands
interface ManagementEthernet — configures the Management port on the system (either the Primary or
Standby RPM).
speed (Management interface) — sets the speed for the Management interface.
show arp
Display the ARP table entries learned on a switch CPU.
C9000 Series
Syntax
show arp [cpu [cp | rp]] [interface interface | ip ip-address [mask] |
macaddress mac-address mask] [static | dynamic] [summary]
Parameters
cpu cp (OPTIONAL) Enter the keywords cpu cp to display the ARP entries learned on
the Control Processor.
cpu rp (OPTIONAL) Enter the keyword cpu rp to display the ARP entries learned on the
Route Processor.
interface
interface
To specify an interface, enter one of the following interface types and slot/port or
number information:
● For Loopback interfaces, enter the keyword loopback then a number from
zero (0) to 16383.
● For a Port Channel interface, enter the keyword port-channel then a
number. The range is from 1 to 4096.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
●
For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
● For a tunnel interface, enter the keyword tunnel.
● For a port extender (PE) Gigabit Ethernet interface, enter the keyword peGigE
then the pe-id/ stack-unit unit number /port-ID information.
linecard slot-id (OPTIONAL) Enter the interface port-type slot/port parameters to
display the ARP entries learned on a Z9500 port. The range of slot IDs is from 0 to
2.
ip ip-address
mask
(OPTIONAL) Enter the keyword ip with an IP address in the dotted decimal
format to display the ARP entries learned with this IP address. Enter the optional IP
address mask in the slash prefix format (/ x).
904 IPv4 Routing