Users Guide

Related
Commands
hash-algorithm ecmp — changes the hash algorithm across an ECMP.
management route
Configure a static route that points to the Management interface or a forwarding router.
C9000 Series
Syntax
management route {{ip-address mask | {ipv6-address prefix-length}}
{forwarding-router-address | managementethernet | fortyGigE | vlan |
gigabitethernet | tengigabitethernet}}
To remove a static route, use the no management route{{ip-address mask | {ipv6-
address prefix-length}}{forwarding-router-address | managementethernet |
fortyGigE | vlan | gigabitethernet | tengigabitethernet}} command.
Parameters
ip-address mask Enter an IP address (dotted decimal format) and mask (/prefix format) of the
destination subnet.
ipv6-address
prefix-length
Enter an IPv6 address (x:x:x:x::x format) and mask (/prefix format) of the
destination subnet. Enter the IPv6 address in the x:x:x:x::x format followed by the
prefix length in the /x format.
The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
forwarding-
router-address
Enter an IP address (dotted decimal format) or an IPv6 address (x:x:x:x::x format)
of a forwarding router.
managementethe
rnet
Enter the keyword managementethernet for the Management interface on the
Primary RPM.
fortyGigE Enter the keyword fortyGigE to specify a forty Gigbit Ethernet interface.
vlan Enter the keyword vlan to specify a vlan interface.
gigbitethernet Enter the keyword gigabitethernet to specify a one Gigabit Ethernet
interface.
tengigabitethern
et
Enter the keyword tengigabitethernet to specify a ten Gigabit Ethernete interface.
Defaults Not configured.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.7(0.1) Introduced on the S3048-ON.
9.7(0.1) Introduced on the S4048-ON.
9.7(0.0) Added support for forty gigabit, vlan, and tengigabit ethernet interfaces.
Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
IPv4 Routing 903