Users Guide

ip mtu
Set the IP MTU (frame size) of the packet the RPM transmits for the line card interface. If the packet must be fragmented, the
system sets the size of the fragmented packets to the size specified in this command.
C9000 Series
Syntax
ip mtu value
To return to the default IP MTU value, use the no ip mtu command.
Parameters
value Enter the maximum MTU size if the IP packet is fragmented. The range is from 576
to 9234. The default is 1500 bytes.
Defaults 1500 bytes
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
6.1.1.0 Introduced on the E-Series.
Usage
Information
When you enter the no mtu command, the system reduces the ip mtu value to 1536 bytes. To return the
IP MTU value to the default, use the no ip mtu command.
Compensate for Layer 2 header when configuring link MTU on an Ethernet interface or the system may
not fragment packets. If the packet includes a Layer 2 header, the difference between the link MTU and
IP MTU (the ip mtu command) must be enough bytes to include for the Layer 2 header.
Link MTU and IP MTU considerations for Port Channels and VLANs are as follows
Port Channels:
● All members must have the same link MTU value and the same IP MTU value.
● The Port Channel link MTU and IP MTU must be less than or equal to the link MTU and IP MTU values
configured on the channel members. For example, if the members have a link MTU of 2100 and an IP
MTU 2000, the Port Channel’s MTU values cannot be higher than 2100 for link MTU or 2000 bytes for
IP MTU.
VLANs:
● All members of a VLAN must have same IP MTU value.
● Members can have different Link MTU values. Tagged members must have a link MTU 4 bytes higher
than untagged members to account for the packet tag.
● The VLAN link MTU and IP MTU must be less than or equal to the link MTU and IP MTU values
configured on the VLAN members. For example, the VLAN contains tagged members with Link MTU
of 1522 and IP MTU of 1500 and untagged members with Link MTU of 1518 and IP MTU of 1500. The
VLAN’s Link MTU cannot be higher than 1518 bytes and its IP MTU cannot be higher than 1500 bytes.
The following describes the difference between Link MTU and IP MTU.
IPv4 Routing
895