Users Guide

Version Description
E-Series legacy
command
Usage
Information
IGMP commands accept only non-VLAN interfaces — specifying VLAN does not yield results. This
command displays packets for IGMP and IGMP snooping.
ip igmp access-group
Specify access control list for packets in access-group.
C9000 Series
Syntax
ip igmp access-group access-list
To remove the feature, use the no ip igmp access-group access-list command.
Parameters
access-list Enter the name of the extended ACL (16 characters maximum).
Defaults Not configured
Command Modes INTERFACE (conf-if-interface-slot/port)
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.5(0.1) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the C-Series and S-Series.
7.6.1.0 Introduced on the E-Series.
Usage
Information
The access list accepted is an extended ACL. The ip igmp access-group command allows you to
block IGMP reports from hosts, on a per-interface basis based on the group address and source address
that you specify in the access list.
ip igmp group-join-limit
Set a limit to the number of IGMP groups that can be joined in a second,
C9000 Series
Syntax
ip igmp group-join-limit number
Parameters
number Enter the number of IGMP groups permitted to join in a second. The range is from 1
to 10000.
Defaults none
844 Internet Group Management Protocol (IGMP)