Users Guide

Field Description
Ports Lists the interfaces assigned to this port channel.
(untitled) Displays the status of the physical interfaces (up or down).
● In Layer 2 port channels, an * (asterisk) indicates which interface is the primary
port of the port channel. The primary port sends out interface PDU.
● In Layer 3 port channels, the primary port is not indicated.
Example
Dell# sh int por 1 br
LAG Mode Status Uptime Ports
1 L2 up 00:00:08 Te 2/0 (Up) *
Te 2/1 (Down)
Te 2/2 (Up)
Dell#
Example (port-
range)
Dell#show interfaces port-channel 1-2 brief
Codes: L - LACP Port-channel
O - OpenFlow Controller Port-channel
A - Auto Port-channel
I - Internally Lagged
LAG Mode Status Uptime Ports
1 L3 down 00:00:00 Te 11/1 (Down)
Related
Commands
show lacp — displays the LACP matrix.
show port-channel-flow
Display an egress port in a given port-channel flow.
C9000 Series
Syntax
show port-channel-flow outgoing-port-channel number incoming-interface
interface {source-ip address destination-ip address} | {source-port number
destination-port number} | {src-mac address dest-mac address {vlan vlanid |
ether-type}}
Parameters
outgoing-port-
channel number
Enter the keywords outgoing-port-channel then the number of the port
channel to display flow information.
● For a Port Channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
incoming-
interface
interface
Enter the keywords incoming-interface then the interface type and slot/port
or number information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a Gigabit Ethernet interface, enter the keyword gigabitethernet then
the slot/port information.
● For a port extender (PE) Gigabit Ethernet interface, enter the keyword peGigE
then the peid/stack-unit/port-pipe id information.
NOTE: The peGigE option is available only when the extended bridge feature
is enabled.
Interfaces 773