Users Guide

NOTE: In a Jumbo-enabled system, all members of a Port Channel must be configured with the same
link MTU values and the same IP MTU values.
Example
Dell(conf)# int port-channel 2
Dell(conf-if-po-2)#
Related
Commands
channel-member — adds a physical interface to the LAG.
interface — configures a physical interface.
interface loopback — configures a Loopback interface.
interface null — configures a null interface.
interface vlan — configures a VLAN.
shutdown — disables/enables the port channel.
minimum-links
Configure the minimum number of links in a LAG (Port Channel) that must be in “oper up” status for the LAG to be also in “oper
up” status.
C9000 Series
Syntax
minimum-links number
Parameters
number Enter the number of links in a LAG that must be in “oper up” status. The range is
from 1 to 16. The default is 1.
Defaults 1
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.0 Introduced on the E-Series.
Usage
Information
If you use this command to configure the minimum number of links in a LAG that must be in “oper up”
status, the LAG must have at least that number of “oper up” links before it can be declared as up. For
example, if the required minimum is four, and only three are up, the LAG is considered down.
768 Interfaces