Users Guide

Related
Commands
● show config — displays the interface configuration.
Egress Interface Selection (EIS) Commands
The following commands are Egress Interface Selection (EIS) commands.
application
Configure the management egress interface selection.
C9000 Series
Syntax
application {all | application-type}
To remove a management application configuration, use the no application {all |
application-type} command.
Parameters
application-type Enter any of the following keywords:
● For DNS, enter the keyword dns.
● For FTP, enter the keyword ftp.
● For NTP, enter the keyword ntp.
● For Radius, enter the keyword radius.
● For sFlow collectors, enter the keyword sflow-collector.
● For SNMP (traps and MIB responses), enter the keywords snmp .
● For SSH, enter the keyword ssh .
● For Syslog, enter the keyword syslog.
●
For TACACS, enter the keyword tacacs.
● For Telnet, enter the keyword telnet.
● For TFTP, enter the keyword tftp.
all Configure all applications.
Defaults None.
Command Modes EIS Mode (conf-mgmt-eis)
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
9.2.(0.0) Introduced on the Z9000, S4810, and S4820T.
Interfaces 761