Users Guide

Example (Vlan)
Dell(conf-if-vl-20)# interface vlan 10
Dell(conf-if-vl-10)# no untagged te 2/0
Dell(conf-if-vl-10)# interface vlan 20
Dell(conf-if-vl-20)# no tagged te 2/0
Dell(conf-if-vl-20)# interface te 2/0
Dell(conf-if-te-2/0)# no portmode hybrid
Dell(conf-if-vl-20)#
Related
Commands
● show interfaces switchport — displays the configuration of switchport (Layer 2) interfaces on the
switch.
● switchport — places the interface in a Layer 2 mode.
● vlan-stack trunk — specifies an interface as a trunk port to the Stackable VLAN network.
rate-interval
Configure the traffic sampling interval on the selected interface.
C9000 Series
Syntax
rate-interval seconds
Parameters
seconds Enter the number of seconds for which to collect traffic data. The range is from 5
to 299 seconds.
NOTE: Because polling occurs every 15 seconds, the number of seconds
designated here rounds to the multiple of 15 seconds lower than the entered
value. For example, if 44 seconds is designated, it rounds to 30; 45 to 59
seconds rounds to 45.
Defaults 299 seconds
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced
Usage
Information
The output of the show interfaces command displays the configured rate interval, along with the
collected traffic data.
Related
Commands
show interfaces — displays information on physical and virtual interfaces.
716 Interfaces