Users Guide

Example
Dell(conf)# interface null 0
Dell(conf-if-nu-0)#
Related
Commands
● interface — configures a physical interface.
● interface loopback — configures a Loopback interface.
● interface port-channel — configures a port channel.
● interface vlan — configures a VLAN.
● ip unreachables — enables generation of internet control message protocol (ICMP) unreachable
messages.
interface range
This command permits configuration of a range of interfaces to which subsequent commands are applied (bulk configuration).
Using the interface range command, you can enter identical commands for a range of interface.
C9000 Series
Syntax
interface range interface, interface,...
Parameters
interface,
interface,...
Enter the keywords interface range and one of the interfaces — slot/port,
port-channel, or VLAN number. Select the range of interfaces for bulk
configuration. You can enter up to six comma-separated ranges. Spaces are not
required between the commas. Comma-separated ranges can include VLANs, port-
channels, and physical interfaces.
Slot/Port information must contain a space before and after the dash. For example,
interface range tengigabitethernet 0/1 - 5 is valid; interface
range tengigabitethernet 0/1-5 is NOT valid.
● For a Gigabit Ethernet interface, enter the keyword GigabitEthernet then
the slot/port information.
● For a Port Channel interface, enter the keywords port-channel then a
number. The range is from 1 to 4096.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
● For a Tunnel interface, enter the keyword Tunnel then a number from 1 to
16383.
● For a Port Extender Gigabit Ethernet interface, enter the keyword peGigE
then the pe-id / stack-unit / port-id information. The pe-id range is from 0 to
255; the stack-unit unit-number range is from 0 to 7; and the port-id range is
from 1 to 48.
Defaults
none
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
Interfaces 703