Users Guide

● For a Gigabit Ethernet interface, enter the keyword GigabitEthernet then
the slot/port information.
● For a Loopback interface, enter the keyword loopback then the slot/port
information. The range is from 0 to 16383.
● For a Management Ethernet interface, enter the keyword
managementethernet then the slot/port information.
● For a null interface, enter the keyword null then the slot/port information.
The Null interface number is 0.
● For a Port Channel interface, enter the keyword port-channel then the
port-channel ID. Range is from 1 to 4096.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a Tunnel interface, enter the keyword tunnel then the tunnel ID. The
range is from 1 to 16383.
● For a VLAN interface, enter the keyword vlan then the slot/port information.
The range is from 1 to 4094.
● For a port extender Gigabit Ethernet interface, enter the keyword peGigE then
the pe-id / stack-unit / port-id information. The pe-id range is from 0 to 255;
the stack-unit unit-number range is from 0 to 7; and the port-id range is from 1
to 48.
group interface (Optional) Enter the keyword group to configure an interface group. You can
create a interface group by adding a comma or hyphen separate list of the
following interface types:
● fortyGigE for a 40–Gigabit Ethernet interface.
● gigabitethernet for a GigabitEthernet interface.
● peGigE for a PE Gigabit Ethernet interface.
● TengigabitEthernet for a 10-Gigabit Ethernet interface.
● vlan for a VLAN interface.
range (Optional) Enter the keyword range to configure an interface range.
Defaults Not configured.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.4.1.0 Introduced
Usage
Information
You cannot delete a physical interface.
Interfaces 699