Users Guide

Dell#show running-config interface vlan 33
!
interface Vlan 33
private-vlan mode isolated
no ip address
shutdown
Related
Commands
show running-config— displays the current configuration.
duplex (Management)
Set the mode of the Management and Port Extender Gigabit Ethernet (PeGigE) interfaces.
C9000 Series
Syntax
duplex {half | full}
To return to the default setting, use the no duplex command.
Parameters
half Enter the keyword half to set the Management interface to transmit only in one
direction.
full Enter the keyword full to set the Management interface to transmit in both
directions.
Defaults Not configured.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Documentation modified — added Management to distinguish from duplex
(10/100 Interfaces).
Usage
Information
This command applies to the Management interface on the route processor modules (RPMs) and port
extender (PE) ports.
Related
Commands
● interface ManagementEthernet — configures the Management port on the system (either the
Primary or Standby RPM).
● management route — configures a static route that points to the Management interface or a
forwarding router.
● speed (Management interface) — sets the speed on the Management interface.
696 Interfaces