Users Guide

Version Description
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage
Information
You can also use the disable command from port extender(PE) console to turns off access to the
privileged mode commands.
do
Allow the execution of most EXEC-level commands from all CONFIGURATION levels without returning to the EXEC level.
C9000 Series
Syntax
do command
Parameters
command Enter an EXEC-level command.
Defaults none
Command Modes
● CONFIGURATION
● INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage
Information
The following commands are not supported by the do command:
● enable
● disable
● exit
● config
Example
Dell(conf-if-te-5/0)#do clear counters
Clear counters on all interfaces [confirm]
68 Control and Monitoring