Users Guide

Version Description
9.2(1.0) Introduced on the Z9500.
7.4.1.0 Introduced on the E-Series.
Usage
Information
Enables periodic audits of the software and hardware copies of the IPv4 forwarding table. Use this
command in Configuration Terminal Batch mode to enable the audits in the chassis connected in a dual-
homing setup.
clear alarms
Clear alarms on the system.
C9000 Series
Syntax
clear alarms
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage
Information
This command clears alarms that are no longer active. If an alarm situation is still active, it is seen in the
system output.
clear line
Reset a terminal line.
C9000 Series
Syntax
clear line {line-number | console 0 | vty number}
Parameters
line-number Enter a number for one of the 12 terminal lines on the system. The range is from 0
to 11.
console 0 Enter the keywords console 0 to reset the console port.
64 Control and Monitoring