Users Guide

Example
Dell(conf-router_bgp)#show config
!
router bgp 45
neighbor suzanne peer-group
neighbor suzanne no shutdown
neighbor sara peer-group
neighbor sara shutdown
neighbor 13.14.15.20 peer-group suzanne
neighbor 13.14.15.20 shutdown
neighbor 123.34.55.123 peer-group suzanne
neighbor 123.34.55.123 shutdown
Dell(conf-router_bgp)#
Related
Commands
capture bgp-pdu max-buffer-size — specifies a size for the capture buffer.
show ip bgp
View the current BGP IPv4 routing table for the system.
C9000 Series
Syntax
show ip bgp [vrf vrf-name] [ipv4 unicast] [network [network-mask] [longer-
prefixes]]
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf and then the name of the VRF to view ipv4–
unicast route information corresponding to that VRF.
ipv4 unicast (OPTIONAL) Enter the keywords ipv4 unicast to view information only related
to ipv4 unicast routes.
network (OPTIONAL) Enter the network address (in dotted decimal format) of the BGP
network to view information only on that network.
network-mask (OPTIONAL) Enter the network mask (in slash prefix format) of the BGP network
address.
longer-prefixes (OPTIONAL) Enter the keywords longer-prefixes to view all routes with a
common prefix.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.8(0.0) Introduced on the S3048–ON and S4048–ON.
9.7(0.0) Introduced on the S6000–ON.
9.4.(0.0) Added support for VRF.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Added the add-path option to the S4810. Output on the S4810 shows the
ADDPATH parameters.
Border Gateway Protocol 381