Users Guide

Version Description
7.7.1.0 Introduced on the C-Series.
Usage
Information
You can use the redistribute command to advertise the IGP cost as the MED on redistributed routes.
When you set the route-map with metric-type internal and apply outbound to an EBGP peer/peer-group,
the advertised routes corresponding to those peer/peer-groups have the IGP cost set as MED.
When you enter the redistribute isis process-id command without any other parameters, the
system redistributes all OSPF internal routes, external type 1 routes, and external type 2 routes. RFC does
not support this feature.
router bgp
To configure and enable BGP, enter ROUTER BGP mode.
C9000 Series
Syntax
router bgp as-number
To disable BGP, use the no router bgp as-number command.
Parameters
as-number Enter the AS number. The range is from 1 to 65535 (2 byte), from 1 to 4294967295
(4 byte), or from 0.1 to 65535.65535 (dotted format).
Defaults Not enabled.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information
At least one interface must be in Layer 3 mode for the router bgp command to be accepted. If no
interfaces are enabled for Layer 3, an error message appears:
% Error: No router id
configured
Example
Dell(conf)# router bgp 3
Dell(conf-router_bgp)#
378 Border Gateway Protocol