Users Guide

To remove a weight value, use the no neighbor {ip-address | peer-group-name} weight
command.
Parameters
ip-address Enter the IP address of the peer router in dotted decimal format.
peer-group-name Enter the name of the peer group to disable all routers within the peer group.
weight Enter a number as the weight. The range is from 0 to 65535. The default is 0.
Defaults 0
Command Modes ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information
In the best path selection process, the path with the highest weight value is preferred.
NOTE: In the best-path selection process, the path with the highest weight value is preferred.
If you configure the set weight command in a route map applied to this neighbor, the weight set in
that command overrides the weight set in the neighbor weight command.
Related
Commands
set weight — assigns a weight to all paths meeting the route map criteria.
network
Specify the networks for the BGP process and enter them in the BGP routing table.
C9000 Series
Syntax
network ip-address mask [route-map map-name]
To remove a network, use the no network ip-address mask [route-map map-name]
command.
Parameters
ip-address Enter an IP address in dotted decimal format of the network.
mask
Enter the mask of the IP address in the slash prefix length format (for
example, /24).
The mask appears in command outputs in dotted decimal format (A.B.C.D).
route-map map-
name
(OPTIONAL) Enter the keyword route-map then the name of an established
route map.
Only the following ROUTE-MAP mode commands are supported:
Border Gateway Protocol 373