Users Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

321

322

323

324

325

326

327

328

329

330

Version Description

9.9(0.0) Introduced on the C9010.

9.2(1.0) Introduced on the Z9500.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.8.1.0 Introduced on the S-Series.

7.7.1.0 Introduced on the C-Series.

Usage

Information

When a BGP cluster contains only one route reflector, the cluster ID is the route reflector’s router ID. For

redundancy, a BGP cluster may contain two or more route reflectors. Assign a cluster ID with the bgp

cluster-id command. Without a cluster ID, the route reflector cannot recognize route updates from

the other route reflectors within the cluster.

The default format for displaying the cluster-id is dotted decimal, but if you enter the cluster-id as an

integer, it is displayed as an integer.

Commands

bgp client-to-client reflection — enables route reflection between the route reflector and clients.

neighbor route-reflector-client — configures a route reflector and clients.

show ip bgp cluster-list — views paths with a cluster ID.

bgp confederation identifier

Configure an identifier for a BGP confederation.

C9000 Series

Syntax

bgp confederation identifier as-number

To delete a BGP confederation identifier, use the no bgp confederation identifier as-

number command.

Parameters

as-number

Enter the AS number. The range is from 0 to 65535 (2 byte), from 1 to

4294967295 (4 byte), or from 0.1 to 65535.65535 (dotted format).

Defaults Not configured.

Command Modes ROUTER BGP

Command

History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.