Users Guide

show config — displays the current configuration.
permit
Configure a filter to permit packets from a specific source IP address to be processed and forwarded to another interface on
the switch.
C9000 Series
Syntax
permit {source [mask]| any | host ip-address}[count [byte]] [dscp value]
[order] [fragments] [log [interval minutes] [threshold-in-msgs [count]]
[monitor]
To remove this filter, you have two choices:
● Use the no seq sequence-number command if you know the filter’s sequence number.
● Use the no permit {source [mask] | any | host ip-address} command.
Parameters
source Enter the IP address in dotted decimal format of the network from which the
packet was sent.
mask (OPTIONAL) Enter a network mask in /prefix format (/x) or A.B.C.D. The mask,
when specified in A.B.C.D format, may be either contiguous or non-contiguous.
any Enter the keyword any to specify that all routes are subject to the filter.
host ip-address Enter the keyword host then the IP address to specify a host IP address.
count (OPTIONAL) Enter the keyword count to count packets that the filter processes.
byte (OPTIONAL) Enter the keyword byte to count bytes that the filter processes.
dscp (OPTIONAL) Enter the keyword dcsp to match to the IP DSCP values.
order (OPTIONAL) Enter the keyword order to specify the QoS priority for the ACL
entry. The range is from 0 to 254 (where 0 is the highest priority and 254 is the
lowest; lower-order numbers have a higher priority). If you do not use the keyword
order, the ACLs have the lowest order by default (255).
fragments Enter the keyword fragments to use ACLs to control packet fragments.
log (OPTIONAL) Enter the keyword log to include ACL messages in the log.
threshold-in
msgs count
(OPTIONAL) Enter the threshold-in-msgs keyword followed by a value to
indicate the maximum number of ACL logs that can be generated, exceeding which
the generation of ACL logs is terminated with the seq, permit, or deny
commands. The threshold range is from 1 to 100.
interval minutes (OPTIONAL) Enter the keyword interval followed by the time period in minutes
at which ACL logs must be generated. The threshold range is from 1 to 10 minutes.
monitor (OPTIONAL) Enter the keyword monitor when the rule is describing the traffic
that you want to monitor and the ACL in which you are creating the rule is applied
to the monitored interface. For more information, refer to the “Flow-based
Monitoring” section in the Port Monitoring chapter of the Dell Networking OS
Configuration Guide.
Defaults Not configured.
Command Modes CONFIGURATION-STANDARD-ACCESS-LIST
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
218 Access Control Lists (ACL)