Users Guide

clear counters ip access-group
Erase all counters maintained for access lists.
C9000 Series
Syntax
clear counters ip access-group [access-list-name]
Parameters
access-list-name
(OPTIONAL) Enter the name of a configured access-list, up to 140 characters.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Increase the name string to accept up to 140 characters. Prior to 7.8.1.0, names
were up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
ip access-group
Assign an IP access list (IP ACL) to an interface.
C9000 Series
Syntax
ip access-group access-list-name {in | out} [implicit-permit] [vlan vlan-
id]
To delete an IP access-group configuration, use the no ip access-group access-list-name
{in | out} [implicit-permit] [vlan vlan-id] command.
Parameters
access-list-name
Enter the name of a configured access list, up to 140 characters.
in Enter the keyword in to apply the ACL to incoming traffic.
out Enter the keyword out to apply the ACL to outgoing traffic.
implicit-permit (OPTIONAL) Enter the keyword implicit-permit to change the default action
of the ACL from implicit-deny to implicit-permit (that is, if the traffic does not
match the filters in the ACL, the traffic is permitted instead of dropped).
vlan
vlan-id
(OPTIONAL) Enter the keyword vlan then the ID numbers of the VLANs. The
range is from 1 to 4094 (you can use IDs from 1 to 4094).
212 Access Control Lists (ACL)