Manualshelf

Users Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch
211212213214215216217218219220
Related
Commands
show config — displays the current ACL configuration.
show config
Display the current ACL configuration.
C9000 Series
Syntax
show config
Command Modes
● CONFIGURATION-IP ACCESS LIST-STANDARD
● CONFIGURATION-IP ACCESS LIST-EXTENDED
● CONFIGURATION-MAC ACCESS LIST-STANDARD
● CONFIGURATION-MAC ACCESS LIST-EXTENDED
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.11.1 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Example
Dell(config-ext-nacl)#show conf
!
ip access-list extended patches
Dell(config-ext-nacl)#
Common IP ACL Commands
The following commands are available within both IP ACL modes (Standard and Extended) and do not have mode-specific
options. When an ACL is created without a rule and then is applied to an interface, ACL behavior reflects an implicit permit.
The C9000 supports both Ingress and Egress IP ACLs.
NOTE: Also refer to the Commands Common to all ACL Types section.
Access Control Lists (ACL) 211