Users Guide

Version Description
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
ntp master <stratum>
Configure an NTP master and peers.
C9000 Series
Syntax
ntp master <stratum>
Parameters
ntp
master <stratum>
Enter the stratum number to identify the NTP Server's hierarchy.
Defaults Not configured.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.6(0.0) Introduced on the S-Series and Z-Series.
ntp multicast client
To receive NTP information from the network via multicast, configure the switch.
C9000 Series
Syntax
ntp multicast client [multicast-address]
To disable multicast reception, use the no ntp multicast client [multicast-address]
command.
Parameters
multicast-
address
(OPTIONAL) Enter a multicast address. Enter either an IPv4 address in dotted
decimal format or an IPv6 address in X:X:X:X::X format. If you do not enter a
multicast address, the address:
● 224.0.1.1 is configured if the interface address is IPv4
● ff05::101 is configured if the interface address is IPv6
Defaults Not configured.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
1616 System Time and Date