Users Guide

offset Enter one of the following:
● a number from 1 to 23 as the number of hours in addition to universal time
coordinated (UTC) for the timezone.
● a minus sign (-) then a number from 1 to 23 as the number of hours.
Defaults Not configured.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage
Information
Coordinated universal time (UTC) is the time standard based on the International Atomic Time standard,
commonly known as Greenwich Mean time. When determining system time, include the differentiator
between UTC and your local timezone. For example, San Jose, CA is the Pacific Timezone with a UTC
offset of -8.
debug ntp
Display network time protocol (NTP) transactions and protocol messages for troubleshooting.
C9000 Series
Syntax
debug ntp {adjust | all | authentication | events | loopfilter | packets |
select | sync}
To disable debugging of NTP transactions, use the no debug ntp {adjust | all |
authentication | events | loopfilter | packets | select | sync} command.
Parameters
adjust Enter the keyword adjust to display information on NTP clock adjustments.
all Enter the keyword all to display information on all NTP transactions.
authentication Enter the keyword authentication to display information on NTP
authentication transactions.
events Enter the keyword events to display information on NTP events.
loopfilter Enter the keyword loopfilter to display information on NTP local clock
frequency.
packets Enter the keyword packets to display information on NTP packets.
select Enter the keyword select to display information on the NTP clock selection.
sync Enter the keyword sync to display information on the NTP clock synchronization.
1612 System Time and Date