Users Guide
If you do not configure this command, no traps controlled by this command are sent. If you do not specify
a notification-type and notification-option, all traps are enabled.
Related
Commands
snmp-server community — enables SNMP and sets the community string.
snmp-server host — configures an SNMP trap receiver.
snmp-server engineID
Configure the name for both the local and remote SNMP engines on the router.
C9000 Series
Syntax
snmp-server engineID [local engineID] [remote ip-address vrf management
udp-port port-number engineID]
To return to the default, use the no snmp-server engineID [local engineID] [remote ip-
address vrf management udp-port port-number engineID] command.
Parameters
local
engineID
Enter the keyword local followed by the engine ID number that identifies the
copy of the SNMP on the local device.
Format (as specified in RFC 3411): 12 octets.
● The first four octets are set to the private enterprise number.
● The remaining eight octets are the MAC address of the chassis.
remote
ip-
address
Enter the keyword remote followed by the IP address that identifies the copy of
the SNMP on the remote device.
vrf
management
(OPTIONAL) Enter the keyword vrffollowed by the keyword management to
specify that management vrf will be used to reach the remote host.
udp-port
port-
number engineID
Enter the keywords udp-port followed by the user datagram protocol (User
Datagram Protocol) port number on the remote device. The range is from 0 to
65535. The default is 162.
Defaults As above.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage
Information
Changing the value of the SNMP Engine ID has important side effects. A user’s password (entered on the
command line) is converted to a message digest algorithm (MD5) or secure hash algorithm (SHA)
security digest. This digest is based on both the password and the local Engine ID. The command line
password is then destroyed, as required by RFC 2274. Because of this deletion, if the local value of the
1530 Simple Network Management Protocol (SNMP) and Syslog