Users Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

1371

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.

9.9(0.0) Introduced on the C9010.

9.2(1.0) Introduced on the Z9500.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

6.1.1.1 Introduced on the E-Series

Usage

Information

Use the default pre-defined profiles or configure your own profile. You cannot delete the pre-defined

profiles or their default values. This command enables WRED configuration mode —(conf-wred).

Use this command in Configuration Terminal Batch mode to create the WRED profile in a dual-homing

setup.

Commands

threshold — specifies the minimum and maximum threshold values of the WRED profile.

show hardware

This command displays hardware buffer configurations and counters.

C9000 Series

Syntax

show hardware {linecard number | pe-unit number stack-unit number} buffer

unit number port number buffer-info

Parameters

linecard Line card 0 – 11.

pe-unit PE-unit is use to specify the PE. PE ID 1 – 255.

stack-unit Stack-unit is used to specify the statck unite in the stacked PE system. Stack-unit

within a PE ID 0 – 7.

buffer-unit Buffer unit is used to specify the port-pipe. Buffer-unit 0 – 0.

Defaults None

Command Modes Exec

Command

History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.