Users Guide

source (port monitoring)
Configure a port monitor source.
C9000 Series
Syntax
source interface | range destination interface direction {rx | tx | both}
To disable a monitor source, use the no source interface destination interface
direction {rx | tx | both} command.
Parameters
source interface Enter the one of the following keywords and slot/port information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a port channel interface, enter the keyword port-channel and a port-
channel ID.
● For a port extender (PE) Gigabit Ethernet interface, enter the keyword peGigE
then the pe-id / stack-unit / port-id information.
● For a VLAN interface, enter the keyword VLAN and a vlan-id number. Range is
from 1 to 4094.
● For a remote VLAN interface, enter the keyword Remote-VLAN and a vlan-id
number. Range is from 1 to 4094
● For a port channel interface, enter the keyword port-channel and a port-
channel ID.
NOTE: You cannot configure VLAN 4092 and 4093. These VLANs are reserved
for internal use.
range Enter the keyword range to specify the list of interfaces.
destination Enter the keyword destination to specify the destination interface.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a port channel interface, enter the keyword port-channel and a the
port-channel ID.
● For a remote VLAN interface, enter the keyword Remote-VLAN and a vlan-id
number. Range is from 1 to 4094
interface Enter the one of the following keywords and slot/port information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a VLAN interface, enter the keyword VLAN and a vlan-id number. Range is
from 1 to 4094.
● For a port channel interface, enter the keyword port-channel amd a the
port-channel ID.
direction {rx | tx
| both}
Enter the keyword direction then one of the packet directional indicators.
● rx: to monitor receiving packets only.
● tx: to monitor transmitting packets only.
● both: to monitor both transmitting and receiving packets.
Port Monitoring 1321