Users Guide

show monitor session
Display port extender (PE) Gigabit Ethernet interface monitoring information.
C9000 Series
Syntax
show monitor session {session-ID}
To display monitoring information for all sessions, use the show monitor session command.
To display monitoring information for port extender interface, when added as a source port, use the do
show monitor session command in CONFIGURATION mode.
Parameters
session-ID (OPTIONAL) Enter a session identification number. The range is from 0 to 65535.
Defaults none
Command Modes
● CONFIGURATION
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.5(0.1) Introduced on the Z9500.
9.4.0.0 Added support for the RPM / ERPM.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale.
7.7.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Example
Dell#show monitor session
SessID Source Destination Dir Mode SourceIP DestIP DSCP TTL Drop Rate
----- ----- ---------- --- ---- -------- ------ ---- --- --- ---
1 PeGi 0/0/0 Te 10/2 rx Port N/A N/A N/A N/A No N/A
Related
Commands
monitor session — creates a monitoring session.
Port Monitoring 1319