Users Guide

You can provision a port extender connected in a Dual-Homing setup from the Configuration Terminal
Batch mode.
To de-provision a port extender, use the no pe provision pe-id command.
NOTE: You must ensure that the port extender units are offline before you issue the no pe
provision command.
Example
DELL(conf)# pe provision 10
DELL(conf-pe-10)#
DELL(conf)# no pe provision 10
Related
Commands
● feature extended-bridge
● stack unit
● show pe
show config
Display the PE provision configuration details.
C9000 Series
Syntax
show config
Command Modes PE CONFIG (conf-pe-pe-id)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
Example
Dell(conf-pe-5)# show config
!
pe provision 5
stack-unit 4 type C1048P
Dell(conf)#pe 255
Dell(conf-pe-255)#show config
!
pe provision 255
cascade interface TenGigabitEthernet 6/0
stack-unit 1 type C1048P
show ecid
Display the E-Channel identifier (ECID) information for all or any specified interfaces.
C9000 Series
Syntax
show ecid {interface [interface] | pe pe-id stack—unit unit-number}
1282 Port Extenders (PE)