Users Guide

Version Description
9.9(0.0) Introduced on the C9010.
Usage
Information
The pe pe-id command adds a pre-provisioned PE. The port extender ID (pe-id) range is from 0 to
255. You can add a port extender stack-unit using stack-unit unit number keyword.
To remove a port extender, use the no pe pe-id command.
Example
Entering pe context
DELL(conf)# pe 0
Removing pe 0
DELL(conf)# no pe 0
Entering port extender configuration mode:
DELL(conf)#pe 10
DELL(conf-pe-10)#
DELL(conf-pe-10)#stack-unit 0 type c1048P
Related
Commands
● stack-unit – add or delete a specified port extender stack-unit.
● show pe —display the port extender status and details.
pe provision
Logically provision or add a port extender (PE).
C9000 Series
Syntax
pe provision pe-id
To de-provision or delete a port extender, use the no pe provision pe-id command.
Parameters
pe provision pe-
id
Enter port-extender configuration mode to logically provision a port extender. Port
extender ID range is from 0 to 255
Default None
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
Usage
Information
Before you provision a port extender, enable the extended bridge feature using the feature extended
—bridge command. The pe provision pe-id command logically pre-provisions or adds a port
extender (PE) even when the PE is not physically connected to the switch. The port extender ID (pe-id)
range is from 0 to 255.
After provisioning a PE using the pe provision pe-id , you can provision a stack unit using the
stack-unit command.
Port Extenders (PE) 1281