Users Guide

● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
linecard slot-id Enter the keyword linecard and the slot ID. The linecard slot-id range is from 0
to 9.
pe pe-id Enter the keyword pe and the PE ID. The range is from 0 to 255.
stack-unit unit
number
Enter the keyword stack-unit and the stack unit number. The range is from 0 to
7.
rpm slot-id Enter the keyword rpm and specify the route processor slot ID. RPM slot-id values
are rpm0 and rpm1 .
on |off Turn the location LED(s) of the specified interfaces, linecard, port extenders (PE),
ports and RPMs on or off.
Default
None
Command Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
Usage
Information
When the location LED setting is turned “on” for a port extender (PE), the main power supply LED on the
PE flashes green light and when the location LED setting is turned ”off”, the main power supply LED is in
a solid green state.
Thelocation-led settings are not saved through power cycles if the C1048 system is power cycled.
Example
Dell#
Dell#location-led pe 255 stack-unit 0 on
pe
Add a pre-provisioned port extender (PE) .
C9000 Series
Syntax
pe pe-id
To remove a port extender, use the no pe pe-id command.
Parameters
pe pe-id Enter keyword pe and PE ID. The range is from 0 to 255.
Default None
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1280 Port Extenders (PE)