Users Guide

show ip pim snooping interface
Display information on VLAN interfaces with PIM-SM snooping enabled.
C9000 Series
Syntax
show ip pim snooping interface [vlan vlan-id]
Parameters
vlan vlan-id (OPTIONAL) Enter a VLAN ID to display information about a specified VLAN
configured for PIM-SM snooping. The valid VLAN IDs range is from 1 to 4094.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.5(0.1) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.4.1.1 Introduced on the E-Series ExaScale.
Usage
Information
The following describes the show ip pim snooping interface commands shown in the following
example.
Field Description
Interface Displays the VLAN interfaces with PIM-SM snooping enabled.
Ver/Mode Displays the PIM version number for each VLAN interface with PIM-SM snooping
enabled:
● v2 = PIM version 2
● S = PIM Sparse mode
Nbr Count Displays the number of neighbors learned through PIM-SM snooping on the
interface.
DR Prio Displays the Designated Router priority value configured on the interface (ip pim
dr-priority command).
DR Displays the IP address of the Designated Router for that interface.
Example (#2)
Dell#show ip pim snooping interface
Interface Ver Nbr DR DR
Count Prio
Vlan 2 v2 3 1 165.87.32.2
PIM-Sparse Mode (PIM-SM) 1263