Users Guide

● For loopback interfaces, enter the keyword loopback then a number from 0
to 16383.
● For tunnel interfaces, enter the keyword tunnel then a number from 0 to
16383.
● For Port Channel groups, enter the keywords port-channel then a number.
The range is from 1 to 128.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a VLAN, enter the keyword vlan then the VLAN ID. The range is from 1 to
4094.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.4(0.0) Added support for VRF on all platforms (Except MXL and STOMP).
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Added support for Multi-Process OSPF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.1 Introduced on the E-Series.
Usage
Information
The following describes the show ip ospf process-id interface command shown in the
following example.
Item Description
TenGigabitEther
net...
This line identifies the interface type slot/port and the status of the OSPF protocol
on that interface.
Internet
Address...
This line displays the IP address, network mask and area assigned to this interface.
Process ID... This line displays the OSPF Process ID, Router ID, Network type and cost metric
for this interface.
Transmit Delay... This line displays the interface’s settings for Transmit Delay, State, and Priority. In
the State setting, BDR is Backup Designated Router.
Designated
Router...
This line displays the ID of the Designated Router and its interface address.
Backup
Designated...
This line displays the ID of the Backup Designated Router and its interface address.
Timer intervals... This line displays the interface’s timer settings for Hello interval, Dead interval,
Transmit Delay (Wait), and Retransmit Interval.
1156 Open Shortest Path First (OSPFv2 and OSPFv3)