Users Guide

show config
Display the RA guard policy mode configurations.
C9000 Series
Syntax
show config
Command Modes POLICY LIST CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.7(0.0) Introduced on the S6000-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, and Z9000 switches.
Example
Dell(conf)#ipv6 nd ra-guard policy test
Dell(conf-ra_guard_policy_list)#show config
!
ipv6 nd ra-guard policy test
device-role router
hop-limit maximum 251
mtu 1350
other-config-flag on
reachable-time 540
retrans-timer 101
router-preference maximum medium
trusted-port
Dell(conf-ra_guard_policy_list)#
Related
Commands
● device-role — Specifies the role of the device attached to the port.
● hop-limit — Enables the verification of the advertised hop count limit.
● mtu — Sets the maximum transmission unit (MTU) value.
● other-config-flag — Enables the verification of the advertised other configuration parameter.
● reachable-time — Sets the advertised reachability time.
● retrans-timer — Sets the advertised retransmission time.
● router-preference maximum — Enables the verification of the advertised default router preference
(DRP) value.
show ipv6 neighbors
Display information about the IPv6 neighbors discovered on the switch CPUs.
C9000 Series
Syntax
show ipv6 neighbors [cpu rp] [ipv6–address] {ipv6–address}] [interface
interface [vrf vrf-name]
Neighbor Discovery Protocol (NDP) 1083