Users Guide

match ra
Enable verifying either of the configured source IPv6 address or prefix address or the source MAC address in the inspected
messages. If this command is not configured, the verification process is bypassed.
C9000 Series
Syntax
match ra {ipv6-access-list name | ipv6-prefix-list name | mac-access-list
name}
To reset the access list, use the no match ra{ipv6-access-list | ipv6-prefix-list |
mac-access-list}command.
Parameters
ipv6–access-list
name
Enter the keywords ipv6–access-list then the access-list name. The access-
list name allows a maximum of 140 characters.
ipv6–prefix-list
name
Enter the keywords ipv6–prefix-list then the prefix-list name. The prefix-list
name allows a maximum of 140 characters.
mac-access-list
name
Enter the keywords mac-access-list then the mac-access-list name. The mac-
access-list name allows a maximum of 140 characters.
Defaults none
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
9.7(0.0) Introduced on the S6000-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, and Z9000 switches.
mtu
Enable the verification of the configured maximum transmission unit (MTU) value in the received RA packets.
C9000 Series
Syntax
mtu value
To reset the MTU value, use the no mtu value command.
Parameters
value Enter the maximum transmission unit value in bytes. The range is from 1,280 to
11,982 bytes.
Defaults 0
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Neighbor Discovery Protocol (NDP) 1079