Users Guide

NOTE: The :: notation specifies successive hexadecimal fields of zero.
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to clear the
neighbor corresponding to that VRF.
NOTE: If you do not specify this option, the neighbors in the default VRF are
cleared.
interface
interface
To remove all neighbor entries learned on a specific interface, enter the keyword
interface then the interface type and slot/port or number information of the
interface:
Enter one of the following keywords with slot/port or number to clear information
about the IPv6 neighbors learned on the specified interface:
● For a 1–Gigabit Ethernet interface, enter the keyword GigabitEthernet
then the slot/port information
● For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a port-channel interface, enter the keyword port-channel with a port-
channel number. The range of port-channel numbers is from 1 to 4096.
● For a VLAN interface, enter the keywordvlan then a number from 1 to 4094.
● For a tunnel interface, enter the keyword tunnel.
Command Modes
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.7(0.0) Added support for VRF.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.1 Introduced on the S4810.
device-role
Specify the role of the device attached to the port.
C9000 Series
Syntax
device-role {host | router}
To reset the device role, use the no device-role {host | router} command.
Parameters
host Enter the keyword host to set the device-role as host.
router Enter the keyword router to set the device-role as router.
Neighbor Discovery Protocol (NDP) 1075