Users Guide

To return to the default, use the no advertise med location-identification
{coordinate-based value | civic-based value | ecs-elin value} command.
Parameters
coordinate-based
value
Enter the keywords coordinate-based then the coordinated based location in
hexadecimal value of 16 bytes.
civic-based value Enter the keywords civic-based then the civic based location in hexadecimal
format. The range is from 6 to 255 bytes.
ecs-elin value Enter the keywords ecs-elin then the Emergency Call Service (ecs) Emergency
Location Identification Number (elin) numeric location string. The range is from 10
to 25 characters.
Defaults unconfigured.
Command Modes CONFIGURATION (conf-lldp)
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series and E-Series.
Usage
Information
● ECS — Emergency call service such as defined by TIA or the national emergency numbering
association (NENA)
● ELIN — Emergency location identification number, a valid North America Numbering Plan format
telephone number supplied for ECS purposes.
Related
Commands
debug lldp interface — debugs LLDP.
show lldp neighbors — displays the LLDP neighbors.
show running-config lldp — displays the LLDP running configuration.
advertise med power-via-mdi
Configure the system to advertise the IEEE 802.1ab extended power via MDI TLV.
C9000 Series
Syntax
[no] advertise med power-via-mdi
To return to the default, use the no advertise med power-via-mdi command.
Defaults unconfigured.
Command Modes
● LLDP CONFIGURATION (conf-lldp)
● INTERFACE LLDP CONFIGURATION (conf-if-interface-lldp)
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
Link Layer Discovery Protocol (LLDP) 1033