Users Guide

clear lldp neighbors
Clear LLDP neighbor information for all interfaces or a specific interface.
C9000 Series
Syntax
clear lldp neighbors {interface}
Parameters
interface Enter the following keywords and slot/port or number information:
● For a 1–Gigabit Ethernet interface, enter the keyword gigabitethernet
then the slot/ port information.
● For a 10-Gigabit Ethernet interface, enter the keyword
tenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a Management Ethernet interface, enter the keyword
managementethernet then the slot/port information.
● For a port extender (PE) Gigabit Ethernet interface, enter the keyword peGigE
then the pe-id / stack-unit / port-id information.
Defaults none
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
debug lldp interface
To display timer events, neighbor additions or deletions, and other information about incoming and outgoing packets, enable
LLDP debugging.
C9000 Series
Syntax
debug lldp interface {interface | all}{events | packet {brief | detail} {tx
| rx | both}}
To disable debugging, use the no debug lldp interface {interface | all}{events}
{packet {brief | detail} {tx | rx | both}} command.
Link Layer Discovery Protocol (LLDP) 1019