Users Guide

Version Description
6.2.1.1 Introduced on the E-Series.
Related
Commands
show lacp — displays the LACP configuration.
debug lacp
Debug LACP (configuration, events, and so on).
C9000 Series
Syntax
debug lacp {config | events | pdu [interface-type [in | out]]}
To disable LACP debugging, use the no debug {config | events | pdu [interface-type
[in | out]]} command.
Parameters
config (OPTIONAL) Enter the keyword config to debug the LACP configuration.
events (OPTIONAL) Enter the keyword events to debug the LACP event information.
pdu (OPTIONAL) Enter the keyword pdu to debug the LACP Protocol Data Unit
information.
interface-type in
| out
(OPTIONAL) Enter the following keywords and slot/port or number information:
● For a Gigabit Ethernet interface, enter the keyword GigabitEthernet then
the slot/port information.
● For a Ten-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a port extender Gigabit Ethernet interface, enter the keyword peGigE then
the pe-id / stack-unit / port-id information. The pe-id range is from 0 to 255;
the stack-unit unit-number range is from 0 to 7; and the port-id range is from 1
to 48.
Optionally, enter an in or out parameter:
● Receive enter in
● Transmit enter out
Defaults none
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
1008 Link Aggregation Control Protocol (LACP)