Reference Guide

Installation Instructions RMT2/RLT2/RXT2
11
Switching Interface Brackets (Optional)
For wide hole patterns, interface brackets must be reversed.
See Table below to determine if this is necessary.
1. Remove the tilt tension knob, washer and screw from
interface bracket. (See Figure 11)
IMPORTANT ! : Hold the brackets steady when removing
the knob, washer and screw from interface bracket to
prevent internal washers from falling out. If internal
washers do fall out, they must be reinserted in proper
position before reinstalling knob on the other side!
2. Replace the knob, washer and screw in the opposite order.
(See Figure 11)
Figure 11
3. Repeat for the other interface bracket.
4. Install interface brackets according to instructions in Install
Brackets to Display section.
Tilt Adjustment
1. Adjust tilt tension adjustment knobs to desired tension. (See
Figure 12)
2. Adjust tilt of display by pulling the top of display away from
the wall until desired tilt position is reached. (See Figure 12)
3. Tighten tilt tension adjustment knobs to secure tilt position.
(See Figure 12)
Figure 12
Table 1: Hole Pattern Width
Model #
normal installation swap uprights
RMT2 100-440mm 441-506mm
RLT2 100-663mm 664-728.8mm
RXT2 200-847mm 848-913mm
1
2
2
1 3
tilt tension adjustment
knob