Reference Guide

RMT2/RLT2/RXT2 Installation Instructions
10
Install Display to Wall Plate
WARNING: Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components attached does not exceed 125 lbs (56.7 kg)
for the RMT2 and RLT2 or 175 lbs (79.4 kg) for the RXT2.
Use with products heavier than the maximum weight
indicated may result in collapse of the mount and its
accessories causing possible injury.
WARNING: Display may be very heavy! Ensure display
can be safely lifted and maneuvered as required to install on
wall plate. Failure to take adequate precautions can result in
serious personal injury or damage to equipment!
WARNING: Interface brackets must be hung on opposite
sides of the center tab on wall plate! (See Figure 9)
Figure 9
1. Make sure interface brackets are in the kickstand position by
pulling down on handles as far as possible. (See Figure 10)
2. Hang display with brackets (B and C) on upper rail of wall
plate (A). Kickstand should be engaged with lower portion
of wall plate. (See Figure 10)
Figure 10
NOTE:
Any cable management or rear display adjustments
should be made when the display is resting on the
kickstand.
3. Unlock kickstand by pushing up on interface brackets until
kickstand rests against the wall. (See Figure 10)
4. Push up on the interface brackets further in order to lock
display into position against wall. (See Figure 10)
5. Straps can be tucked behind display on notch on interface
brackets (B and C) after installation is complete so that they
will not be visible to the viewer. (See Figure 9)
6. (Optional) Route padlock or cable lock (not included)
through bottom holes on interface bracket to provide
additional security. (See Figure 10)
center tab
of center tab
5
interface
brackets
must be
hung on
opposite sides
4
2
kickstand engaged
1
kickstand
against wall
3
6
(Views from left side)