Command Line Reference Guide

96 | Control and Monitoring
www.dell.com | support.dell.com
ip tftp source-interface
c e s
Assign an interface’s IP address in outgoing packets for TFTP traffic.
Syntax
ip tftp source-interface interface
Parameters
Defaults
The IP address on the system that is closest to the Telnet address is used in the outgoing packets.
Command Modes
CONFIGURATION
Command
History
line
c e s
Enable and configure console and virtual terminal lines to the system. This command accesses LINE
mode, where you can set the access conditions for the designated line.
Syntax
line {aux 0 | console 0 | vty number [end-number]}
Parameters
interface
Enter the following keywords and slot/port or number information:
• For an 100/1000 Ethernet interface, enter the keyword
GigabitEthernet followed by
the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the
slot/port information.
• For Loopback interfaces, enter the keyword
loopback followed by a number from zero
(0) to 16383.
• For a Port Channel, enter the keyword
port-channel followed by a number:
C-Series and S-Series: 1-128
E-Series: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for ExaScale
• For the SONET interfaces, enter the keyword
sonet followed by slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed
by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/
port information.
• For a VLAN interface, enter the keyword
vlan followed by a number from 1 to 4094.
Version 8.4.6.0
Added support for the keyword
fortyGigE.
Version 8.2.1.0 Increased number of VLANs on ExaScale to 4094 (was 2094)
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
aux 0 Enter the keyword aux 0 to configure the auxiliary terminal connection.
Note: This option is supported on E-Series only.
console 0 Enter the keyword console 0 to configure the console port.
The console option for the S-Series is <0-0>.