Command Line Reference Guide

786 | IPv6 Border Gateway Protocol (IPv6 BGP)
www.dell.com | support.dell.com
Related
Commands
network backdoor
c e
Specify this IGP route as the preferred route.
Syntax
network ipv6-address prefix-length backdoor
To remove a network, use the no network ipv6-address prefix-length backdoor command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Usage
Information
Though Dell Networking OS does not generate a route due to backdoor config, there is an option for
injecting/sourcing a local route in presence of network backdoor config on a learned route.
redistribute
c e
Redistribute routes into BGP.
Syntax
redistribute {connected | static} [route-map map-name]
To disable redistribution, use the no redistribution {connected | static} command.
Parameters
redistribute Redistribute routes into BGP.
ipv6-address prefix-length Enter the IPv6 address in the x:x:x:x::x format followed by the prefix
length in the
/x format.
Range: /0 to /128
The
:: notation specifies successive hexadecimal fields of zeros.
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
connected Enter the keyword connected to redistribute routes from physically connected
interfaces.
static Enter the keyword static to redistribute manually configured routes.
These routes are treated as incomplete routes.
route-map
map-name
(OPTIONAL) Enter the keyword route-map followed by the name of an established
route map.
Only the following ROUTE-MAP mode commands are supported:
• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
• set ipv6 next-hop
If the route map is not configured, the default is deny (to drop all routes).