Command Line Reference Guide

630 | Interfaces
www.dell.com | support.dell.com
Related
Commands
show port-channel-flow
c e s
Display an egress port in a given port-channel flow.
Syntax
show port-channel-flow outgoing-port-channel number incoming-interface interface
{source-ip address destination-ip address} | {protocol number | icmp | tcp | udp} |
{source-port number destination-port number} | {source-mac address destination-mac
address}
Parameters
Ports Lists the interfaces assigned to this port channel.
(untitled)
Displays the status of the physical interfaces (
up or down).
In Layer 2 port channels, an * (asterisk) indicates which interface is the
primary port of the port channel. The primary port sends out interface
PDU.
In Layer 3 port channels, the primary port is not indicated.
Table 23-13. show interfaces port-channel brief Command Example Fields
Field Description
show lacp Display the LACP matrix.
outgoing-port-channel
number
Enter the keyword outgoing-port-channel followed by the
number of the port channel to display flow information.
• For a Port Channel interface, enter the keyword
port-channel
followed by a number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and
1 to 512 for ExaScale.
incoming-interface interface Enter the keyword incoming-interface followed by the interface
type and slot/port or number information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet
followed by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a SONET interface, enter the keyword
sonet followed by the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
source-ip address Enter the keyword source-ip followed by the IP source address in
IP address format.
destination-ip address Enter the keyword destination-ip followed by the IP destination
address in IP address format.
protocol number | icmp | tcp
|
udp
On the E-Series only, enter the keyword protocol followed by one of
the protocol type
keywords:
tcp, udp, icmp or protocol number
Note: The protocol number keyword applies to E-Series only.